Access Denied
IMPORTANT! If you’re a store owner, please make sure you have Customer accounts enabled in your Store Admin, as you have customer based locks set up with EasyLockdown app. Enable Customer Accounts
Commercial Heat Press Settings
Print PDF Commercial Heat Press Instructions
Print PDF Wash/Care Instructions
Acceptable Fabric Type: 100% Cotton, 100% Polyester, Poly/Cotton Blends, Polyester Mesh, Rayon, Satin, Silk, Modal, Linen, Cotton or Polyester Canvas, Denim, Burlap(smooth weave only), Fleece (not all fabric types may be listed)
*Will NOT adhere to non-fabric surfaces, Spandex/Lycra(cotton blends upto 5%), 100% Nylon, any Nylon Blend, Nylon Mesh, Nylon Canvas or fabrics marked “Do Not Iron”
Step #1: Inspect your transfers for any damage or missing pieces (sorry, we are not perfect, but we will replace the item!) If we missed weeding a design/letter, gently fold back the transfer adhesive side up and remove piece with your fingers/tweezers. Smooth any air bubbles.
Step #2: Use the sample piece provided to check the presses temperature and pressure settings
Temperature: 300°
Heat Sensitive Fabrics: Preheat using a lower, then work up the heat in small increments as needed until you reach the optimal application temperature to avoid scorching the fabric, use low-medium pressure
Step #3: Place your garment(unwashed is best, but washed will still work) on the lower platen. Thicker fabrics such as fleece or denim place as a single layer. Teflon pillow may be used inside the garment
Step #4: PREHEAT GARMENT Press garment with iron for 8-10 seconds over the area where the design will be applied.
Step #5: Remove and discard white paper backing, and place transfer face up on the garment
Step #6: Cover the transfer with either a Teflon cover sheet or Kraft paper. The top platen should never come into direct contact with the clear transfer mask
Step #7: Press with iron for 10-15 seconds* using Medium Pressure (#5 on Stahls Hottronix)
*thinner fabric may require LESS time/pressure, heavier/thicker fabric may require MORE time/pressure
Step #8: Allow the shirt & transfer to cool down for several minutes, the transfer and shirt should be WARM but not hot to the touch
Step #9: Once the transfer is cool, peel off the clear plastic sheet(peeling the plastic too soon will tear the vinyl & it will lift off the shirt as the adhesive needs several minutes to set)
Step #10: Cover design with the cover sheet and press again for 4-6 seconds
TIP: If pressing both sides of the garment, place Teflon pillow between the fabric layers, apply the design on the opposite side
Please note that transfers are shipped weeded and masked, even though these steps are included in the videos
Videos are courtesy of SiserNA the manufacturer of the heat transfer vinyl we use
Invalid password
Enter